How to bead a waterfall necklace by DIY Jewelry Making

How to bead a waterfall necklace by DIY Jewelry Making


Materials needed: 4mm clear bicones, 4mm red bicones Pass the needles thought the beads in zig zag manner to reach the clear beads next the the 2nd red beads. It would be the clear bicone from the third unit. Now we are going to form the dangling beads below the necklace. Insert 1 clear bicones followed by 3 red bicones. Pass the needle back to the first clear bicones added just now. You have just form one unit below the necklace. To form the second dangling, pass the needle to the next clear bicones. For every new dangling we are adding, we will add 1 more clear bicones than the previous dangling. So for the second dangling, insert 2 clear bicones, followed by 3 red bicones. Pass the needle back to the 2 clear bicones. Repeat the process to form the third dangling. For the 3 dangling, you will need to add 3 clear bicones before adding the red ones. Repeat the process till you have the 15th dangling. On the 8th dangling, you would have 8 clear bicones that formed the longest dangling positioned at the centre of the necklace. From the 9th dangling, you should have one less bicones for each dangling you make. once you have completed the last dangling, pass the thread through a few more beads till point D in diagram. You may get a new thread to pass through all beads to tighten the necklace. Once this is completed, the necklace is completed!

35 Comments

  1. What kind of thread did you use for this project so I can get the right kind. Also… I need to the size and kind of clasp that you used for this too???

Leave a Reply

Your email address will not be published.


*